The paper presents the methodology for designing the injection shaft drive for diesel engines with 2,3,4,6 and 8 cylinders as well as power from 2.5 to 52 kW per cylinder using the FEM method and experimental research. The pump is the original solution of the authors. The shaft is a basic part of the pump with a complex structure. In order to assess the state of stress in the shaft, the FEM analytical method was used and experimental tests were carried out, subjecting the shaft to torsional moment resulting from the transmitted power. Experimental studies confirmed the results of numerical calculations and the correctness of the adopted solution. The destructive tests were carried out to assess the maximum load capacity of the shaft, loading it with an increasing torque until visible plastic deformations occurred. This condition appeared at twice the moment (Ms = 602 Nm) in relation to the maximum predicted moment in operation (extreme operating conditions of the pump shaft). The theoretical studies confirmed very significant stress concentration (αk coefficient at the level of 2.63 or even 4.7), which may be the cause of fatigue cracks. It also determines the strength of the shaft and its torsional stiffness, which influences the proper functioning of the pump and ensures adequate fuel injection phases.
Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies
Informacja
SZANOWNI CZYTELNICY!
UPRZEJMIE INFORMUJEMY, ŻE BIBLIOTEKA FUNKCJONUJE W NASTĘPUJĄCYCH GODZINACH:
Wypożyczalnia i Czytelnia Główna: poniedziałek – piątek od 9.00 do 19.00