Effects Of Process Parameters On Cu Powder Synthesis Yield And Particle Size In A Wet-Chemical Process Wpływ parametrów procesu na wydajność syntezy proszku Cu i wielkości cząstek w procesie mokrym chemicznym
This study presents a simple wet-chemical process to prepare several micron-size Cu powders. Moreover, changes in powder synthesis yield and particle size are examined with different solvents, synthesis temperatures, and amounts of reducing agent during the synthesis. As a reducing agent and capping agent, L-ascorbic acid and polyvinyl pyrrolidone were used, respectively. The yields in distilled water or an ethylene glycol (EG)/distilled water mixture were higher than that in EG alone, and the yield increased with increasing temperature owing to a lower Δ Gred value. Increasing the L-ascorbic acid concentration also increased the yield. The Cu powder synthesized in 3 h at 90°C in distilled water with 272.8 mM of L-ascorbic acid showed the lowest average particle size of 2.52 μm, indicating mechanisms of short burst nucleation and reduced growth via the increased reduction rate of Cu ions. It is estimated that the nucleation step was nearly completed within 10 min in this system. The Cu powders synthesized in an ethylene glycol/distilled water mixture presented an average particle size of 3.76 μm and the highest yield of 87.9%.
Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies
Informacja
SZANOWNI CZYTELNICY!
UPRZEJMIE INFORMUJEMY, ŻE BIBLIOTEKA FUNKCJONUJE W NASTĘPUJĄCYCH GODZINACH:
Wypożyczalnia i Czytelnia Główna: poniedziałek – piątek od 9.00 do 19.00