Acoustic emission is one of the effective techniques used for the condition monitoring of rolling element bearings. Contamination
is one of the major reasons for bearing early failure due to presence of solid particle in lubricant grease. In most cases, outer
race is stationary and the inner race is attached to the rotating assembly. The lubrication is very essential for the bearing to perform
under various demanding conditions. The main aim of this project is to analyze the effect of contamination of lubricant by solid
particles on the dynamic behavior of rolling bearing. Green sand at three concentration levels 5%, 15%, 25% and different particle
sizes 75 μm, 106 μm and 150μm is used to contaminate the lubricant. Experimental tests have been performed for different load and
speed condition in good and contaminated ball bearings lubricated with grease. The trends in the amount of AE waves affected by the
contamination of the grease were determined. Acoustic emission signals were analyzed in terms of RMS, kurtosis, and peak-peak.
Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies
Informacja
SZANOWNI CZYTELNICY!
UPRZEJMIE INFORMUJEMY, ŻE BIBLIOTEKA FUNKCJONUJE W NASTĘPUJĄCYCH GODZINACH:
Wypożyczalnia i Czytelnia Główna: poniedziałek – piątek od 9.00 do 19.00