Carbon fiber reinforced polymeric (CFRP) composite materials are widely used in aerospace, automobile and biomedical
industries due to their high strength to weight ratio, corrosion resistance and durability. High speed machining (HSM) of CFRP
material is needed to study the impact of cutting parameters on cutting forces and chip microstructure which offer vital inputs to the
machinability and deformation characteristics of the material. In this work, the orthogonal machining of CFRP was conducted by varying
the cutting parameters such as cutting speed and feed rate at high cutting speed/feed rate ranges up to 346 m/min/ 0.446 mm/rev.
The impact of the cutting parameters on cutting forces (principal cutting, feed and thrust forces) and chip microstructure were
analyzed. A significant impact on thrust forces and chip segmentation pattern was seen at higher feed rates and low cutting speeds.
Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies
Informacja
SZANOWNI CZYTELNICY!
UPRZEJMIE INFORMUJEMY, ŻE BIBLIOTEKA FUNKCJONUJE W NASTĘPUJĄCYCH GODZINACH:
Wypożyczalnia i Czytelnia Główna: poniedziałek – piątek od 9.00 do 19.00