This article presents results of comparative studies into the roughness (very significant tribological factor) of surfaces cut using the AWJM method. Cutting was performed on samples made of quenched and tampered alloy steel (1.2080), plastic (polyamide PA6) and mineral material (syenite). Variable parameters in the cutting process included: jet pressure and feed. As a result of measurements involving selected roughness parameters (Ra, Rz and Rq), it was discovered that the majority of variable factors had a significant effect on the cut surface roughness. It was also demonstrated that the contact method measurements cannot be performed with regard to plastics because the results are characterised by a very great scatter of results values, making them unreliable.
Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies
Informacja
SZANOWNI CZYTELNICY!
UPRZEJMIE INFORMUJEMY, ŻE BIBLIOTEKA FUNKCJONUJE W NASTĘPUJĄCYCH GODZINACH:
Wypożyczalnia i Czytelnia Główna: poniedziałek – piątek od 9.00 do 19.00