This article describes the design and construction of a feed drive load measuring system based on industrial strain gauges installed in the machine tool structure. The system was calibrated and dynamically tested in the range of 15 kN in real machining conditions. The tests showed that the system installed on a machine tool works correctly and its error amounts to about 5% of the measured range. Thanks to this measuring system the accuracy of the machine tool in machining conditions can be increased through the active compensation of the axial error caused by displacements. Moreover, the system can prevent tool breakage and increase machining efficiency.
Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies
Informacja
SZANOWNI CZYTELNICY!
UPRZEJMIE INFORMUJEMY, ŻE BIBLIOTEKA FUNKCJONUJE W NASTĘPUJĄCYCH GODZINACH:
Wypożyczalnia i Czytelnia Główna: poniedziałek – piątek od 9.00 do 19.00