Abstract In this work, the mass throughput rate in a radiation processing center, equipped with an X-ray facility, is calculated by means of a curve against the thickness of the material, along with the variation of dose uniformity. Therefore, depending on the desired dose value, the best thickness and the mass throughput rate can be calculated. The calculation results for the 5 and 10 MeV X-ray bremsstrahlung for polyethylene and wood as the irradiation products, have been obtained by using a Monte-Carlo computer code. In addition, the experimental results at the same geometry and materials were compared with those calculated.
Ta witryna wykorzystuje pliki cookies do przechowywania informacji na Twoim komputerze. Pliki cookies stosujemy w celu świadczenia usług na najwyższym poziomie, w tym w sposób dostosowany do indywidualnych potrzeb. Korzystanie z witryny bez zmiany ustawień dotyczących cookies oznacza, że będą one zamieszczane w Twoim komputerze. W każdym momencie możesz dokonać zmiany ustawień dotyczących cookies
Informacja
SZANOWNI CZYTELNICY!
UPRZEJMIE INFORMUJEMY, ŻE BIBLIOTEKA FUNKCJONUJE W NASTĘPUJĄCYCH GODZINACH:
Wypożyczalnia i Czytelnia Główna: poniedziałek – piątek od 9.00 do 19.00